Problem

General discussion about all things Tooli
Phillip C
Posts: 4
Joined: Sun Jun 26, 2016 3:25 am

Problem

Postby Phillip C » Thu Jun 30, 2016 1:43 pm

My machine will not go past a screen stating "coulor change requireed". Any ideas on what is wrong?

Greg R
Posts: 24
Joined: Sun Jun 26, 2016 3:13 am

Re: Problem

Postby Greg R » Thu Jun 30, 2016 8:20 pm

I too had this issue, on one file. I was able to re-process out the file in the Art2GCode web app and didn't have the problem after that. Not sure what the issue was - but if there is something that could be done to avoid this, or to understand why it did this, that would be helpful.

User avatar
Toolbotics Support
Posts: 55
Joined: Sat Jun 25, 2016 10:29 am

Re: Problem

Postby Toolbotics Support » Fri Jul 01, 2016 12:42 am

You should only see the color change screen when running a job, and only if there's a color change event in the G code. Is this the case, or has the color change screen appeared while not running a job?
Toolbotics Forum Support

Greg R
Posts: 24
Joined: Sun Jun 26, 2016 3:13 am

Re: Problem

Postby Greg R » Fri Jul 01, 2016 5:44 pm

When I experienced the issue, it was immediately upon trying to start a job. I believe my error was in the processing steps of Art2GCode, as I haven't experienced it again after successfully running a few laser jobs.