Connecting to a computer

General discussion about all things Tooli
User avatar
kenn32707
Posts: 35
Joined: Sun Jun 26, 2016 3:35 am

Connecting to a computer

Postby kenn32707 » Wed Jul 06, 2016 4:00 pm

Hi Are there any instruction with connecting the tooli to a computer. mac or pc, useing it as a printer?

User avatar
Toolbotics Support
Posts: 55
Joined: Sat Jun 25, 2016 10:29 am

Re: Connecting to a computer

Postby Toolbotics Support » Thu Jul 07, 2016 1:34 am

Our computer-to-Tooli interface software is still under development and won't be available until later in the year.

We have done some testing with Repetier Host and found it to communicate reliably with Tooli's control board. Repetier Host is open source software developed for communicating with 3D printers. Not all of Tooli's features are supported by Repetier Host, so use it with caution.

https://www.repetier.com/download-now/
Toolbotics Forum Support

User avatar
kenn32707
Posts: 35
Joined: Sun Jun 26, 2016 3:35 am

Re: Connecting to a computer

Postby kenn32707 » Thu Jul 07, 2016 1:42 am

thanks for the reply ill check it out

User avatar
kenn32707
Posts: 35
Joined: Sun Jun 26, 2016 3:35 am

Re: Connecting to a computer

Postby kenn32707 » Fri Dec 09, 2016 8:55 pm

Toolbotics Support wrote:Our computer-to-Tooli interface software is still under development and won't be available until later in the year.

We have done some testing with Repetier Host and found it to communicate reliably with Tooli's control board. Repetier Host is open source software developed for communicating with 3D printers. Not all of Tooli's features are supported by Repetier Host, so use it with caution.

https://www.repetier.com/download-now/



Hi , Have a direct to print solution become available yet??

User avatar
Toolbotics
Site Admin
Posts: 10
Joined: Sun Jun 05, 2016 3:51 am

Re: Connecting to a computer

Postby Toolbotics » Mon Dec 12, 2016 12:45 am

Unfortunately we haven't had time/resources to complete the remote user interface as yet. All going to plan it should be available early-ish in the new year.

Merry Xmas

see-n'-see
Posts: 10
Joined: Sat Jun 25, 2016 5:28 pm

Re: Connecting to a computer

Postby see-n'-see » Sat Dec 24, 2016 5:42 pm

Toolbotics wrote:Unfortunately we haven't had time/resources to complete the remote user interface as yet. All going to plan it should be available early-ish in the new year.

Merry Xmas



Thanks Troy!! :D